If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Servicing/filling a Parker 51
I just bought a Parker 51 with a Vacumatic filler. I managed to fill
the pen and it seems to write fine, although it didn't seem to take up much ink. I have two questions-- 1) Should I do anything to clean the pen, and if so, what? I vaguely remember some people using a solution of water and something to flush out the pen. I also have access to an ultrasonic cleaner if that could be of use. 2) How should I fill the pen most effectively? Right now I'm dipping the pen, pressing the plastic button, waiting a beat, realeasing it, waiting a beat, etc, until no bubbles show up in the ink. Am I filling the pen correctly? If not, what am I doing wrong? Thanks!! -Lotofun |
Ads |
#2
|
|||
|
|||
Servicing/filling a Parker 51
Lot-o-fun writes:
I just bought a Parker 51 with a Vacumatic filler. I managed to fill the pen and it seems to write fine, although it didn't seem to take up much ink. I have two questions-- 1) Should I do anything to clean the pen, and if so, what? I vaguely remember some people using a solution of water and something to flush out the pen. I also have access to an ultrasonic cleaner if that could be of use. Start with just plain cool water. That's enough 99% of the time. Fill the pen, shake the water out (in the case of Vacumatic fillers, that is), repeat. 2) How should I fill the pen most effectively? Right now I'm dipping the pen, pressing the plastic button, waiting a beat, realeasing it, waiting a beat, etc, until no bubbles show up in the ink. Am I filling the pen correctly? If not, what am I doing wrong? If the pen hasn't been restored, the diapragm (a rubber structure underneath the filler button) probably needs to be replaced. It might be 60 years old, after all. http://www.richardspens.com/ref_info/anatomy-vac.htm |
#3
|
|||
|
|||
Servicing/filling a Parker 51
Thanks for the info! I have some followup questions that I hope that
you or some other generous sould will answer. 1) What's a typical fill experience for a Vacumatic Parker 51? With this one, I get 1 bubble out of the pen on each of about 3 presses of the plunger, and that's it. Should there be more? 2) I'm cleaning the pen as you suggested, having removed all the ink and then putting it in water. It's been that way all day. I keep going back and pressing the plunger every hour or so; each time, a little bit of ink comes out on the first few presses. I presume I should keep doing this until no visible ink comes out? Thanks again! -Lotofun In article , L, not -L wrote: On 3-Dec-2005, Lot-o-fun wrote: I just bought a Parker 51 with a Vacumatic filler. I managed to fill the pen and it seems to write fine, although it didn't seem to take up much ink. Sounds like the diaphragm may need to be replaced; follow the fill instructions given at the link I provide later and if it still doesn't take on much ink, you will need to have the fill mechanism restored. I just had two Vac's done by Ron Meloche (rmelo12089 cox.net) and am well pleased with his work. He charges $25 to restore vacumatic fillers I have two questions-- 1) Should I do anything to clean the pen, and if so, what? I vaguely remember some people using a solution of water and something to flush out the pen. I also have access to an ultrasonic cleaner if that could be of use. I have cleaned and resac'ed several hundred pens and have yet to find one that could not be cleaned with just plain water and a little patience (that doesn't mean there aren't any, only that I haven't encountered them). Typically, I will soak the pen, as in the filling position, in an old Sheaffer ink bottle (though a juice glass or similar would do just as well). I have enough water in it to submerge the nib and half the section and let the pen sit for several hours, changing the water whenever it becomes so saturated with ink that it looks more like ink than inky water. Some pens take only a few hours, others a couple of days. If the fill mechanism works, I fill the pen with water when soaking it; the whole idea is to remove the ink residue through the principle of diffusion. The use of ultrasonic cleaners is controversial; some say it can ruin pens and swear at them, others swear by them. IMHO, those who swear by them are either not patient, love gadgets or both. The only time I might be tempted to try one is with a fountain pen that has been ruined with india ink; what have I got to lose in that case? 2) How should I fill the pen most effectively? Right now I'm dipping the pen, pressing the plastic button, waiting a beat, realeasing it, waiting a beat, etc, until no bubbles show up in the ink. Am I filling the pen correctly? If not, what am I doing wrong? Vacumatic filling instructions can be found at http://www.vintagepens.com/filling_i...acumatic.shtml Thanks!! -Lotofun |
#4
|
|||
|
|||
Servicing/filling a Parker 51
Lot-o-fun writes:
Thanks for the info! I have some followup questions that I hope that you or some other generous sould will answer. 1) What's a typical fill experience for a Vacumatic Parker 51? With this one, I get 1 bubble out of the pen on each of about 3 presses of the plunger, and that's it. Should there be more? No, you should get a few bubbles with each plunger press. Your desription sounds like the existing diaphragm is shot. Again, not a surprise given the design and age. Replace it and it'll be good for many years. If you're new to pens and haven't ever done anything like this before, you might want to farm it out. There are lots of good pro pen repair people, and you can get many recommendations from members of the newsgroup. 2) I'm cleaning the pen as you suggested, having removed all the ink and then putting it in water. It's been that way all day. I keep going back and pressing the plunger every hour or so; each time, a little bit of ink comes out on the first few presses. I presume I should keep doing this until no visible ink comes out? Or until you get sick and tired of it. ;-) |
#5
|
|||
|
|||
Servicing/filling a Parker 51
Thanks again for the info!
Tomorrow morning I'll empty all the water out of the pen fill it again with water so I can see how many bubbles I get. How hard is it to replace the diaphragm myself, if I work from one of the diagrams on the web? Are there instructions out there? I'm not a complete klutz and I tend to be pretty good about fixing things if I have good instructions to work from... In article , Tim McNamara wrote: Lot-o-fun writes: Thanks for the info! I have some followup questions that I hope that you or some other generous sould will answer. 1) What's a typical fill experience for a Vacumatic Parker 51? With this one, I get 1 bubble out of the pen on each of about 3 presses of the plunger, and that's it. Should there be more? No, you should get a few bubbles with each plunger press. Your desription sounds like the existing diaphragm is shot. Again, not a surprise given the design and age. Replace it and it'll be good for many years. If you're new to pens and haven't ever done anything like this before, you might want to farm it out. There are lots of good pro pen repair people, and you can get many recommendations from members of the newsgroup. 2) I'm cleaning the pen as you suggested, having removed all the ink and then putting it in water. It's been that way all day. I keep going back and pressing the plunger every hour or so; each time, a little bit of ink comes out on the first few presses. I presume I should keep doing this until no visible ink comes out? Or until you get sick and tired of it. ;-) |
#6
|
|||
|
|||
Servicing/filling a Parker 51
Lot-o-fun wrote:
How hard is it to replace the diaphragm myself, if I work from one of the diagrams on the web? Are there instructions out there? I'm not a complete klutz and I tend to be pretty good about fixing things if I have good instructions to work from... Is this a junker pen? If not, have someone w/more experience do the work for you. If you have never used heat in pen repair or if you do not have a vacumatic tool... have someone else do the work for you. Cleaning the collector is no sweat compared to replacing the diaphragm. Someone with experience and a vacumatic tool can do the job (i.e., clean the collector and replace the diaphragm) in relatively little time and not warp the shell or wreck the filler (the plastic socket into which the the closed end of the diaphragm fits). An experienced repairperson also knows how to maintain the alignment of the filler relative to the barrel thus ensuring a smooth seam between blind cap and barrel without having to sand the heck out of the joint. -- B |
#7
|
|||
|
|||
Servicing/filling a Parker 51
Lot-o-fun writes:
Thanks again for the info! Tomorrow morning I'll empty all the water out of the pen fill it again with water so I can see how many bubbles I get. How hard is it to replace the diaphragm myself, if I work from one of the diagrams on the web? Are there instructions out there? I'm not a complete klutz and I tend to be pretty good about fixing things if I have good instructions to work from... The best instructions are in Da Book: Fountain Pens: the complete guide to repair and resoration by Frank Dubiel (RIP what, two years now? Sigh). Buy it here (in no particular order): http://www.swisherpens.com/catalog/books/books.htm http://www.pendemonium.com/penrepair.htm But not he http://www.biblio.com/details.php?dcx=16721571&src=frg Yikes! Over $300 Canadian.... |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FS - Vintage Parker, Wahl Eversharp, etc. | AFLane | Pens & Pencils | 0 | December 10th 04 03:14 AM |
throw a molotov cocktail through the window of mutt parker | http://tinyurl.com/ii35 | Cards:- non-sport | 1 | November 23rd 04 07:57 AM |
1944 P51B Mustang PARKER 51 | Len Provisor | Pens & Pencils | 0 | September 1st 04 06:29 AM |
Parker DUOFOLD monoplane over Seattle 1928 | Len Provisor | Pens & Pencils | 0 | July 23rd 04 06:17 AM |
The 1944 P51B Mustang PARKER 51 | Len Provisor | Pens & Pencils | 0 | April 4th 04 08:19 AM |