If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
NSM CITY 2
I need to program for freeplay, can this be done from the buttons or do I need
a key pad? does any one know the code? thanks, doc ellis phone or email if you have any questions about pinball repair, |
Ads |
#2
|
|||
|
|||
sorry make that MSN.
doc ellis |
#3
|
|||
|
|||
Hi Doc,
On the left hand side of the control computer is a 4 pin Molex in-line .1" spacing connector. If you short the bottom two pins or install a switch that does the same, you allow the machine to enter into special or free play mode. To make the machine go into free play as opposed to special pricing , you need to set the special pricing option (C3) to all zeros. If you need the programming chart, I can email a scan of it to you. Mark "REllis2007" wrote in message ... I need to program for freeplay, can this be done from the buttons or do I need a key pad? does any one know the code? thanks, doc ellis phone or email if you have any questions about pinball repair, |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
In Person Autographs-Motor City Con | CraigAK62 | Autographs | 2 | September 25th 04 11:43 PM |
Motor CIty Con | CraigAK62 | Autographs | 0 | September 13th 04 09:42 PM |
Motor City Con | CraigAK62 | Autographs | 0 | April 29th 04 11:56 PM |
NSM City II Carriage WTB | Bob Shingledecker | Juke Boxes | 0 | October 3rd 03 08:20 PM |
City II 45 JukeBox NSM | Michael Lenardon | Juke Boxes | 0 | August 17th 03 02:19 PM |