If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Wurlitzer OMT Parts Source
Any recommendations on the best parts source for a Wurlitzer OMT.
Specifically, I am looking for the florescent lamp ballast for the two lower pilaster lamps. Thanks, Mark |
Ads |
#2
|
|||
|
|||
Wurlitzer OMT Parts Source
On Dec 16, 4:16*pm, Mark wrote:
Any recommendations on the best parts source for a Wurlitzer OMT. Specifically, I am looking for the florescent lamp ballast for the two lower pilaster lamps. *Thanks, Mark Part number on the faulty ballast is D-36-22.2-3, which does not correspond with any of the ballasts in the OMT parts list. Mark |
#3
|
|||
|
|||
Wurlitzer OMT Parts Source
Mark wrote:
Any recommendations on the best parts source for a Wurlitzer OMT. Specifically, I am looking for the florescent lamp ballast for the two lower pilaster lamps. Thanks, Mark I'll assume as soon as you install a new bulb, it flashes once then is dead? That is the normal symptom of a bad ballast. You should be able to find one in any hardware or lighting store. Check the bulb for it's Watt rating and get a ballast to go with it. Put in a new starter at the same time. Should cost $5 to $10. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Does anybody have any cabinet parts or a parts machine for a Rockola1455 or a Wurlitzer 2304 | [email protected] | Juke Boxes | 1 | May 24th 09 05:16 AM |
Wurlitzer 3800 parts | FZ | Juke Boxes | 0 | July 23rd 08 01:54 AM |
WTB: Wurlitzer OMT parts | PeteB | Juke Boxes | 1 | April 24th 07 01:27 AM |
Wurlitzer Teledisc Positive TC Resistor Source-WTB | toucanf16 | Juke Boxes | 0 | July 10th 06 06:48 PM |
WANTED WURLITZER PARTS | TERRY BEARDALL | Juke Boxes | 2 | December 21st 03 09:28 PM |