If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Hf100r motor dead
Hi,
I had to dismantle my working 100r in order to restore the cabinet. I have been quite careful but after puttting it togheter motor is dead. Ok, 3A fuse blown. Replaced, blown again... Now I have to trace the problem. I have the service manual but before starting, any ideas of what is more probably the problem? Thanks Lore |
Ads |
#2
|
|||
|
|||
Hf100r motor dead
Probably bent contacts on reversing switch.
Mike On Fri, 23 Mar 2018 00:32:04 -0700 (PDT), Lore wrote: Hi, I had to dismantle my working 100r in order to restore the cabinet. I have been quite careful but after puttting it togheter motor is dead. Ok, 3A fuse blown. Replaced, blown again... Now I have to trace the problem. I have the service manual but before starting, any ideas of what is more probably the problem? Thanks Lore |
#3
|
|||
|
|||
Hf100r motor dead
ahh, right, I finally discovered the contacts on the most left of the reversing switch seem to be shorted. From the manual I see this should be the cancel solenoid ones...
ok, found it opening the top back door, there are two of them. Now, it seems quite difficult to access them and see what happened without taking out the Whole motor block. Any clues to unblock the solenoids (maybe for some reason stuck) or should I start to take out the motor block? Thanks a lot again Il giorno venerdì 23 marzo 2018 15:44:22 UTC+1, Mike Thomas ha scritto: Probably bent contacts on reversing switch. Mike On Fri, 23 Mar 2018 00:32:04 -0700 (PDT), Lore wrote: Hi, I had to dismantle my working 100r in order to restore the cabinet. I have been quite careful but after puttting it togheter motor is dead. Ok, 3A fuse blown. Replaced, blown again... Now I have to trace the problem. I have the service manual but before starting, any ideas of what is more probably the problem? Thanks Lore |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SEEBURG HF100R | [email protected] | Juke Boxes | 2 | August 16th 12 12:57 PM |
motor gripper and the magazine motor | Funkyboye | Juke Boxes | 4 | December 13th 10 04:18 AM |
Seeburg HF100r Parts | Craig Robertson | Juke Boxes | 2 | October 22nd 08 06:48 PM |
Seeburg JL, HF100R Question | Joseph A. Tony Dziedzic | Juke Boxes | 2 | January 9th 05 02:17 PM |
WTB: Rock-ola 78rpm turntable motor DEAD OR ALIVE | C. Basset | Juke Boxes | 0 | April 23rd 04 10:39 AM |