If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
motor gripper and the magazine motor
i remove both of them ,was wondering if its normal that by hand i cannot turn the gear of both motor, its the 1987 rock ola model 1000
|
Ads |
#2
|
|||
|
|||
The gear motors have enough reduction ratio that the only way to ensure it is mechanically operable is to turn the armature shaft protruding through the end of the motor housing. Actuating the motor by turning the gear itself is practically impossible.
|
#3
|
|||
|
|||
Thanks so its normal then, if someone knows where the circuit that power those 2 motor start where, or which fuse its a 1987 kock-ola model 1000 i got all the book but they don't tell which fuse is for what
|
#4
|
|||
|
|||
I vaguely remember working on a model 1000 about 12 or 15 years ago or so. However, the system used was similar to their regular 490 series commerical jukes. You probably should see a power supply assembly below the amplifier on the left side of the back wall of the inside of the jukebox. This power supply should house all of the primary setup voltage fuses. I would think that a visual inspection will reveal if one is blown.
|
#5
|
|||
|
|||
Quote:
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rockola Magazine Drive Motor noise | Rob Blakeslee | Juke Boxes | 3 | February 20th 10 03:32 PM |
Rock-ola 50298-a Gripper Motor Gear * 1960 1484 parts | mailman4 | Juke Boxes | 0 | November 21st 09 11:33 PM |
Gripper motor gear | mailman4 | Juke Boxes | 0 | November 19th 09 06:36 AM |
Rowe R-83 Magazine Motor chatters after scan | joe_x | Juke Boxes | 6 | March 29th 05 09:14 PM |
WTB: gripper motor for AMI Continental II | mike | Juke Boxes | 0 | September 13th 03 06:09 PM |