If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Rowe Ti-1 select coil locking on
Hi folks;
I was wondering if somebody might help me figure out what's going on with my Jukebox. I have a Ti-1... it works pretty good, but lately I've been getting an issue where one of the select coils locks on. I usually won't realize it's done it until the record starts playing over and over again... because the coil is holding the pin down! Anyways, I've looked over the schematics but can't figure it out. What 'kills' the power to that coil? I don't believe the coil itself is bad, because if you turn the service switch off then back on, the coil releases. Sometimes the buttons stay latched in, as well.. so I guess whatever resets the buttons, likely also kills the power to the select coil after it hits the pin. Can somebody point me in the right direction of what I need to test? I've got a multimeter and should be able to check out whatever I need to. Thank you in advance, Ron |
Ads |
#2
|
|||
|
|||
Quote:
I have sent you a few suggestions on one of the other jukebox forums. Regards Alan Hood ami-man UK |
#3
|
|||
|
|||
Rowe Ti-1 select coil locking on
On Jan 11, 4:10*am, Ron Lyons wrote:
Hi folks; * I was wondering if somebody might help me figure out what's going on with my Jukebox. I have a Ti-1... it works pretty good, but lately I've been getting an issue where one of the select coils locks on. *I usually won't realize it's done it until the record starts playing over and over again... because the coil is holding the pin down! Anyways, I've looked over the schematics but can't figure it out. What 'kills' the power to that coil? *I don't believe the coil itself is bad, because if you turn the service switch off then back on, the coil releases. Sometimes the buttons stay latched in, as well.. so I guess whatever resets the buttons, likely also kills the power to the select coil after it hits the pin. Can *somebody point me in the right direction of what I need to test? I've got a multimeter and should be able to check out whatever I need to. Thank you in advance, Ron I have seen this problem caused by R1 having residual magnetism & not releasing when it should. (more likely if your machine is set on free play) Put a piece of business card between the armature and the coil on R1 and see if it works OK. Ray |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FA: US Coil Stamps | TL | Marketplace | 0 | January 25th 08 04:24 AM |
Looking Back #12 - Coil Trailers | Blair (TC) | General Discussion | 7 | August 6th 05 09:25 AM |
Trip Coil | Bob | Juke Boxes | 1 | November 27th 03 02:00 AM |
Can some explain the CORRECT coil codes to me: CV vs CH? | Steve | General Discussion | 1 | November 24th 03 05:42 AM |
Coil in Montblanc converter | Edo | Pens & Pencils | 4 | November 1st 03 11:12 PM |