I'm looking for help wiring from wallbox to stepper

I just bought a Rockola 507 wallbox to go with my 1767 stepper unit
for my 444 jukebox.

Can anyone help me with the layout of the correct plug wiring. It
looks like there is only 1 plug to connect these 2 together?

I'm assuming that would be just for power and the coin mech.?

How would I then connect more than 1 box to that stepper ...I plan on
getting 1-2 more boxes.

And the dumbest question of all...where would I put the stepper unit
in the 444. I did notice 2 screws in the back wall right side of the
jukethat look like they would hold the unit....but a bunch of wires
are in the way.


Thanks for any help.

Ken

Ken,

If you will send me your email address off-list to sales "at" jordanamusement "dot" com, I will send you the setup wiring diagram for connecting the 507 wallbox. The wallboxes "daisy-chain" in parallel fashion from one to the other. I cannot address the physical mounting location on a 444, but would think it to be close to a harness connector with a dummy plug inserted into it. At least, this was the case on later model Rockola jukes.