If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Seeburg L100 Helpppppp
On Aug 31, 10:48*am, Wayne B
wrote: Hi, I'm a newbie with a Seeburg L100. *It's in need of repair and I don't know where to start. *Any suggestions? * Right now the mech scans, but never stops to pick, *the selector buttons do not latch (relay not pulling in) and there is no sound from the amp. *The PCB's do not look discolored, but not all of the tubes are lit. Thank you -- Wayne B HI Wayne, Your machine is somewhat above average in difficulty. Seeburg only made the printed-circuit tube machines one year and found out they were not a good idea. You will need a manual - available at www.alwaysjukin.com You will also need a volt meter. If it hasn't been done you need to replace the original capacitors in the amp & selection receiver. Kits for this are available at www. verntisdale.com Check all fuses for correct values The tubes may not be getting heater voltage if not lit Try wiggling and rocking - you could have corrosion in the socket. Post back with your progress and questions Ray. |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Seeburg L100 | [email protected] | Juke Boxes | 3 | December 2nd 06 08:08 PM |
seeburg L100 popping while mech. is changing directions | flashbk13 | Juke Boxes | 0 | October 12th 05 06:27 AM |
Seeburg L100/101 | flashbk13 | Juke Boxes | 1 | May 13th 05 05:15 PM |
Seeburg L100 manual help | Cy8212 | Juke Boxes | 0 | October 24th 04 04:56 PM |
Seeburg L100 selection problem | Rabbit in Headights | Juke Boxes | 1 | September 10th 04 09:07 PM |