If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
WTB & Tech: Rock-Ola 2000x Laser 2000 Stuff
I just acquired a pretty nice Rock-Ola Laser 2000 (2000X) CD juke and am
looking for a few things for it, and have some simple questions. The questions: I notcied some dips on the keypad and the computer. Does anyone have the settings for these? I have the manual for programming it but can't find anything on the dips. The stuff I am looking for: -- The 2 entry plates that screw onto the coin slot area -- Wireless remote set-up -- Bill validator ANY and all help is appreciated! Thanks! Bill |
Ads |
#2
|
|||
|
|||
WTB & Tech: Rock-Ola 2000x Laser 2000 Stuff
Bill,
The dip switches on the keypad pcb will only set the sequencing of the lamps in the front access door. The original bill validator was a MAKA. It was a total piece of junk. I have modified a 2000-X to use a Mars DBA attached to the front access door. It wasn't too bad cosmetically looking and gave the box extended life in a commercial environment. Something to consider if you are operating it on a cash for play basis. The only wireless remote that was offered on any of the early CD Rock's was RF. It required a receiver unit which was mounted to the top of the inside cabinet. I will look through my files and see if I have any installation instruction. However, most operators at that time would use the VC mounted to the back of the cabinet. Either by leaving it in its original location or running wire for it to the counter / bar area. David |
#3
|
|||
|
|||
WTB & Tech: Rock-Ola 2000x Laser 2000 Stuff
Thanks for the info!
Would you happen the have the dip settings? I just would like to know what all I can set and to try it out. As for the remote volume... I do have an older remote that works on the 1970's jukes. It's NOT the motorized one, so I was thinking of converting it to use on the 2000X. Can I just rip out the pot that's inside the remote and just replace it with one that's the same as what's in the juke? Seems kinda TOO easy to revamp the wired remote to work with this box. Bill "DRebber" wrote in message ... Bill, The dip switches on the keypad pcb will only set the sequencing of the lamps in the front access door. The original bill validator was a MAKA. It was a total piece of junk. I have modified a 2000-X to use a Mars DBA attached to the front access door. It wasn't too bad cosmetically looking and gave the box extended life in a commercial environment. Something to consider if you are operating it on a cash for play basis. The only wireless remote that was offered on any of the early CD Rock's was RF. It required a receiver unit which was mounted to the top of the inside cabinet. I will look through my files and see if I have any installation instruction. However, most operators at that time would use the VC mounted to the back of the cabinet. Either by leaving it in its original location or running wire for it to the counter / bar area. David |
#4
|
|||
|
|||
Bill,
Unless the previous owner replaced the original volume control with something else, the factory volume control was designed to be removed from the back of the back and used as a wired remote. The backing plate for the remote was to be used to cover the hole left in the cabinet. We usually added a terminal strip to the back cabinet wall for connecting the juke harness to our remote wire. That way, we could always keep up with the volume control harness. BTW, the volume control pot is 10K Ohm. We have used the older plastic remotes by replacing the pot and rewiring. I will send you the schema that deals with the DIP switches, but I have to send it from my "work" computer. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
TECH: ROCK-OLA 477 | thabigwolf | Juke Boxes | 5 | April 2nd 08 04:50 PM |
TECH: Rock-ola 445 | [email protected] | Juke Boxes | 2 | July 23rd 07 02:26 PM |
wtb: 56129-a for rock-ola 2000x | [email protected] | Juke Boxes | 1 | November 24th 06 10:22 PM |
tech: rock-ola 478 won't select | pjpin | Juke Boxes | 1 | June 27th 06 11:02 PM |
Tech: Rock-ola 460 | Mike Brower | Juke Boxes | 1 | April 29th 04 03:32 AM |