If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Help needed on Seeburg Entertainer ESTD2
Hi,
I picked up the above juke today and was wondering if someone could give me some pointers with the following problem: The problem appears to be with the brass gear/cog that comes directly off the motor. The gear/cog appears to be spit in two. The bottom half spins freely while the top half doesn't move hence, the mech is not moving. The whole juke also needs a thorough dusting and clean. The mech is also very dry and in need to lube. Has anyone came across this problem? Many thanks in advance. |
Ads |
#2
|
|||
|
|||
There is supposed to be a rubber section between the brass parts. You will
need a new one. If you find a u used one, make sure that the rubber is solidly attached to the brass and it is somewhat soft. A hardened one will cause vibration to the turntable. Mike "David" wrote in message ... Hi, I picked up the above juke today and was wondering if someone could give me some pointers with the following problem: The problem appears to be with the brass gear/cog that comes directly off the motor. The gear/cog appears to be spit in two. The bottom half spins freely while the top half doesn't move hence, the mech is not moving. The whole juke also needs a thorough dusting and clean. The mech is also very dry and in need to lube. Has anyone came across this problem? Many thanks in advance. |
#3
|
|||
|
|||
After looking a little further today. I realied that there should in fact
be rubber between these parts. Do I purchase the part as a whole eg; the brass fittings with the rubber coupling all complete? Any suggestions on where I could find this part new? "Merlin Amusements" wrote in message . com... There is supposed to be a rubber section between the brass parts. You will need a new one. If you find a u used one, make sure that the rubber is solidly attached to the brass and it is somewhat soft. A hardened one will cause vibration to the turntable. Mike "David" wrote in message ... Hi, I picked up the above juke today and was wondering if someone could give me some pointers with the following problem: The problem appears to be with the brass gear/cog that comes directly off the motor. The gear/cog appears to be spit in two. The bottom half spins freely while the top half doesn't move hence, the mech is not moving. The whole juke also needs a thorough dusting and clean. The mech is also very dry and in need to lube. Has anyone came across this problem? Many thanks in advance. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Seeburg Entertainer Pics | David | Juke Boxes | 5 | April 27th 04 03:35 PM |
Keys needed for Seeburg 222 | Matt's Arcade | Juke Boxes | 1 | November 20th 03 02:17 PM |
Seeburg wallbox key needed | Rick Force | Juke Boxes | 3 | September 25th 03 09:07 PM |
Seeburg 201 & W Parts Needed. | StropeDukeofjuke | Juke Boxes | 0 | September 21st 03 01:50 AM |
Seeburg Mechs Needed! | Arthur Dent | Juke Boxes | 0 | August 5th 03 05:30 PM |