If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
estd2 scans twice, selects nothing
ok im a pinball guy but a friend pleaded with me to see what i could
do! its an seeburg estd2, i have followed the guide which describes the problem, i have tried setting the selections all on with the 1.5v battery and nothing gets picked up. when i unplug the RCA connector it will start playing a record when i reconnect, so i assume its not the "sense" bit, also when i tie/bridge the read out load/ trip relay on the test strip of the DEC controller it will pick up each record and play it normally as suggested, it does not miss any nor does it have any issues loading playing or rejecting the current selection. so im assuming that the pulse to the tormat to select is not happening? the keypad obviously works because it scans when a valid selection is entered, or is this flawed thinking? any hints/tips |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Who selects the slogans? | [email protected] | General Discussion | 4 | November 8th 05 07:49 PM |
AMI-120 wallbox selects incorrectly | fuzzybunnies | Juke Boxes | 0 | March 9th 05 01:37 AM |
Help needed on Seeburg Entertainer ESTD2 | David | Juke Boxes | 2 | May 9th 04 11:24 AM |
PostEuro selects "most beautiful stamp" | Bob Ingraham | General Discussion | 4 | December 19th 03 03:04 AM |
99-00 BAP Memo All Star Selects wanted + more | Robert Lindberg | Hockey | 0 | October 12th 03 04:16 PM |