If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Security level change information needed for CD100
My 1990 Rowe Ami Cd100 shows I am at security level 2. Factory default
level should be security level 3 using default code of 0000. Seems someone has changed the default code for level 3 from 0000 to something else. Is there a way to restart the computer to factory default settings so I can go to level 3 to do some changes to this jukebox? Thanks. |
Ads |
#2
|
|||
|
|||
Security level change information needed for CD100
On Mar 11, 7:50 am, "Vic" wrote:
My 1990 Rowe Ami Cd100 shows I am at security level 2. Factory default level should be security level 3 using default code of 0000. Seems someone has changed the default code for level 3 from 0000 to something else. Is there a way to restart the computer to factory default settings so I can go to level 3 to do some changes to this jukebox? Thanks. turn off power, turn on service switch, hold down button 0 & 1 and apply power. Release buttons and turn power on-off again. Machine should be fully factory reset. failing this, unsolder one end of battery and short the battery pads (on PCB not battery) together for about 30 sec. |
#3
|
|||
|
|||
Security level change information needed for CD100
On Mar 10, 6:54 pm, "kreed" wrote:
On Mar 11, 7:50 am, "Vic" wrote: My 1990 Rowe Ami Cd100 shows I am at security level 2. Factory default level should be security level 3 using default code of 0000. Seems someone has changed the default code for level 3 from 0000 to something else. Is there a way to restart the computer to factory default settings so I can go to level 3 to do some changes to this jukebox? Thanks. turn off power, turn on service switch, hold down button 0 & 1 and apply power. Release buttons and turn power on-off again. Machine should be fully factory reset. failing this, unsolder one end of battery and short the battery pads (on PCB not battery) together for about 30 sec. Holding down buttons 0 and 1 worked fine. I appreciate your taking the time to help me out. I knew someone in this fine group could help me out!! Vic |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rowe CD100 Manual Needed | Campbell | Juke Boxes | 2 | December 7th 05 05:42 AM |
Information Needed | Galen Cartright | Coins | 4 | September 12th 05 05:16 AM |
NEEDED cd100 parts | erniejade | Juke Boxes | 1 | October 19th 04 04:41 AM |
Rowe CD100 Part Needed | Spookshow | Juke Boxes | 4 | July 23rd 04 01:57 AM |