If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
TECH: Rockola 464 Problem #2
When you select the second side of the record
to play, example 210, it starts scanning, it does trip the pin, but never stops at selection, Any ideas on this one. Thanks Phil |
Ads |
#2
|
|||
|
|||
TECH: Rockola 464 Problem #2
I've had this on my 454 at times. All I did was to clean all the
contacts on the wobble plate (I believe that's the name) with rubbing alcohol and then it works well. If I'm wrong on the plate name, it's the plate that all the pins are on. Bill When you select the second side of the record to play, example 210, it starts scanning, it does trip the pin, but never stops at selection, Any ideas on this one. Thanks Phil |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
TECH: Rockola 464 Problem | [email protected] | Juke Boxes | 1 | September 13th 07 11:15 PM |
Tech Seeburg LS-2 Problem! | Bud Klass | Juke Boxes | 2 | July 22nd 06 01:25 PM |
TECH: Rowe Bubbler R-91 Problem | pinballjay | Juke Boxes | 1 | January 2nd 06 12:12 AM |
TECH: AMI Continental 1 mech problem | mike | Juke Boxes | 0 | December 31st 03 07:33 PM |
Tech:W1800 selection problem... | Jonas Elofsson | Juke Boxes | 0 | August 10th 03 03:53 PM |