On 01/24/2016 6:00 PM, Dominic Tiberio wrote:
On Sunday, January 24, 2016 at 8:50:05 PM UTC-5, John Robertson wrote:
On 01/24/2016 2:09 PM, Dominic Tiberio wrote:
This is my first post, I recently purchased a Wurlitzer OMT 1015 CD Jukebox for my wife and the previous owners didn't know exactly why it didn't play so I have been working to bring it back to life. I have it able to load a CD but it does not play. The two zeroes on the left side of the display just blink back and forth. I've tried just about everything I can think of but that is all I can get it to do. In service mode I can get it to load a cd and it spins but it stops shortly after trying to read in the TOC (2 seconds or so) and then just sits there.

I haven't seen any info online about the blinking zeroes and was hoping this might be a clue to someone more experienced. Thanks!


http://flippers.com/wurlitzr.html#Troubleshooting

Read the troubleshooting section on switch K7, this sounds like that
problem.

Could also be the Index Light - check that too.

We sell those parts too...

John :-#)#

Thank you, I actually had seen a lot about the K7 online but mine wasn't broken and the switch is good... but what I found was that the K7 actuator was just slightly rotated up and when the gripper arm was going down it all looked good but was not tripping the switch. I adjusted the actuator down a bit and it now functions properly, but it still is not playing CDs.

The gripper arm loads the CD fine and then the CD spins briefly but then stops. I hear a click in the CD Control unit and then the CD spins briefly again, then a click, I think three times and then the CD is returned to the carrier. The red LED on the CD Control unit is always lit. I have tried a jumper on free play and manually adding credits with the button. I have ensured that the correct number of CDs is set and I have tried multiple CDs and tracks. It seems like the TOC is not being read in.

I tried cleaning the laser lens, still nothing. I haven't checked with a camera if the laser is working yet but I plan on doing that. Do you have any suggestions? It is the Wurlitzer CDM3 CD player and the CD Controller just says CD Controller. Any help is appreciated!


If the K7 actuator is shifting then it may be cracked and you may need
to replace it. The new, stronger, ones are black by the way.

As for your other problem, I am assuming here that you have a CDM-3
player (please verify using the photos on my page). If a CDM-3, the
first thing to do is to replace the thermistor, found in the middle of
the interface PCB that is immediately to the left of the SC&C (Selection
and Credit Computer) with a 3A fuse. The thermistor may be causing an
excessive voltage drop and I always replace them.

Second - if the TOC light is not going out AND the CD is spinning, then
something is wrong with either the CDM-3 player OR the CD-Control box
has an issue. However before tearing into that, check the serial number
of your machine against the serial numbers on that page that cover a
problem with bad transistors that can lead to the same symptoms.

I recommend you read the entire page - I wish I was a better technical
writer though...

John :-#)#

--
(Please post followups or tech inquiries to the USENET newsgroup)
John's Jukes Ltd. 2343 Main St., Vancouver, BC, Canada V5T 3C9
(604)872-5757 or Fax 872-2010 (Pinballs, Jukes, Video Games)
www.flippers.com
"Old pinballers never die, they just flip out."