On 10/05/2014, 9:37 AM, wrote:
Hello all - long time no see.

I have a Rock-ola CD Fireball model that I picked up recently in non-working condition. The plastic carriage that affixes the mechanism lift assembly to the rubber belt had broken. I have since replaced this part and reassembled everything but since the tower had to be removed I believe the mech is out of calibration or something needs to be reset.

In the Tests mode I can operate the mechanism left and right as well as move the lift up and down using the keyboard. However, once I exit out of the Tests mode the mechanism tracks left, then right and stops short of the home position and the lift lowers and seems to bind.

Can anyone offer any guidance here? I hope to use this juke in my classic car garage any help would be greatly appreciated!

Mike


Hi Mike,

Well, the service manual is always a good start...have you checked with
rockola.com - they made the machine after all...while they may not offer
tech support directly they should be able to point you to good manuals.
Victoryglass.com, etc, carry good quality reprints of many manuals, not
sure if they cover the CDs.

If you can't find it elsewhere I'm pretty sure I have a copy I can run
off, but it is a bit thick, so there would be a cost for the time (not
the data) and I don't send out PDFs, only paper copies - good quality
mind you, not copies of bad photocopies. Prices start at $35USD for
these fat jukebox manuals.

John :-#)#

--
(Please post followups or tech inquiries to the newsgroup)
John's Jukes Ltd. 2343 Main St., Vancouver, BC, Canada V5T 3C9
(604)872-5757 or Fax 872-2010 (Pinballs, Jukes, Video Games)
www.flippers.com
"Old pinballers never die, they just flip out."