In article , "Ken Doyle" wrote: Should I have a PM (permanent magnet) speaker? Yes. What should the impedance of the voice coil be, 8 ohms? 16 ohms. AMI was weird like this for some reason :/

I have a chance to buy a nice original 201 with super chrome but, keyboard casting is missing a chunk on the right corner. It might be fixable but, just a easy to replace the whole thing. Other than this cosmetic defect, the box works fine and has super sound. So, if anyone out there can help, let...

I took the motors out & all apart & washed all the parts in cleaner of all old grease , everyting looked good and it played fine till it sat for a few weeks now its slow . also cleaned & oiled all the related stuff that runs the record and used the same oil i used in the last 50 phono motors . Is...

Hi, I am going through a find of about 7000 NOS tubes, and I need to know which tubes were used in jukeboxes, can you see any in the list below that I have missed and were used in jukeboxes that I should keep my eyes open for? I know some had an "A" version, so you don't have to tell me I am...

Heh, I'm sure many of you saw my previous tech post, and since I believe I have found the problem, it's time to follow-up with a typical WTB post. :) I need to buy two coils for the reset hammers on the wobble plate. I don't have a manual in front of me, but I believe my 454 manual said they...

Looking to get my amp gone thru & rebuilt for my Seeburg 'G'. Never had any experience with this before...any recommendations? Thanks for the help! The Doctor

Pat - did you try Bob Welke? He's a straight shooter - email him at 'jukeman at tir dot com' Also, that Sergio guy from Laredo is checking up on some 1468 parts for me. Will have him ck on the turntable surround for you. as well Mike "mailman4" wrote in...

I am about to start making room in my shop. I have the following Rockola jukes that will be parted out: 448 - Cosmetics fair - missing amp - some minor parts have been cannabilized. 478 Mystic - cosmetics fair - amp fried - mech gone - rest is in fair condition 480 Techna - Cosmetics rough -...

Well, I went through my pin bank tonight, which wasn't as bad as everyone made it out to be. It's just time consuming. Not that hard. What I was getting was intermittent selections. I had some that worked constantly everytime and some that would work every now and then. I now I have one burnt out...

You might try http://www.verntisdale.com/ . Last time I was at his house he had a bunch of Seeburg mechs in the garage. Glen "Russ Hatfield" wrote in message ... I'm looking for a couple of mechs to go in a few Seeburg R's....

I have a "Red" 1954 AMI F 120 jukebox nicknamed the "Firecracker". This jukebox is in extremly nice original condition. The cabinet and all chrome and metal parts are in excellent condition. This jukebox amplifier section works fine plays a record and sounds great. The record changer mechanism was...

Hi I´am looking for wallhanging speakers for the 40th jukeboxes. If you want to sell one please e-mail me. . Thanks Ray

Ken Doyle wrote: Hi. I finally rebuilt the amp in my Wurlitzer 412. The bear-claw arm and magnetic cartridge actually sounds pretty good, though I may upgrade it later so I can put some of my better records in without wearing them out. I lubed the changer with oil (marvel mystery oil)...

Hi Group - Just picked up a 454 for my folks, and noticed a few cosmetic things I would like to improve. I am looking for a set of the Purple/Blue panels from the front of the machine - not the big center one, but the 2 with the speaker cut-outs. Also looking for a replacement cover for the bill...

Quick question? What is the "Wobble Plate" switch and solenoid and what are they used for? This is located at the rear of the pinbank. I have no clue... Eric

Again, This is a long shot, but is there anyone having the settings for the switches in a Rockola 51375 Credit Unit? It is probably in the service manual I'll get in the mail next week, but I can't wait... :) Eric

Can anyone please help me set up my Rowe/Ami Jukebox to be on constant freeplay. I know how to get into service mode and navigate the menus, but i do not know how to change the values. If anyone can help, I would be extremely grateful...

Anyone have an extra set of schematics for a Rowe R-87 they wouldn't mind letting go? I have a computer from one that I need to repair, and schems and a parts list would be a big help. I would happily buy an original set or a legible copy. I believe R-84 through R-87 should have the same...

Hello, I need a non-working jukebox for a project that I'm working on. All I really need is for it to look complete on the outside, so internal parts missing would be alright. Hoping to find something in the Kansas City/Wichita area, but would drive a ways for the right deal. Thanks.

I assume we are talking about a repro plastic set. The outer plastics seem too wide to go in. I heat them with a hair dryer and flex them a little to get them in. When you hear the "POP" and if your heart is still beating, they will be in place or in two pieces. Good luck, Ed