A collecting forum. CollectingBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » CollectingBanter forum » Collecting newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Juke Boxes Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
SEEBURG SCD-1B by [email protected]
I have a seeburg scd-1b for sale or will part out. Good laser and gripper gear something wrong in the electronics with full coin gear including dollar bill acceptor. $75.00 shipping is on you e-mail at located in prescott az
February 7th 16 10:10 PM
by [email protected] Go to last post
0 498
Wurlitzer 3300 solenoid, relay, or transformer? by George DeShetler Jr
Hello wiser people than my self, I'm helping a friend revive a Wurlitzer 3300. We are currently stuck with the solenoid that holds the selection buttons not fully retracting. And the J1 relay buzzing. I'm wondering if both or either of these are are being caused by a bad 24v transformer? Thank you...
February 6th 16 11:19 PM
by John Robertson Go to last post
3 432
1939 Rock Ola Standard jukebox by Tom DiFruscio
I am having trouble getting any volume on my jukebox. I tried to adjust the volume with the volume control. I installed a new needle but I still am unable to get any volume. i;m not sure what the problem is, can anyone help me?
January 28th 16 04:06 PM
by bruceR Go to last post
2 642
Need a bushing by [email protected]
I have a Wurlitzer 1450 and I need to replace the bushing for the Selector Cam Assembly? I contacted Victory Glass but they do not carry the part. If anyone knows of a supplier or has any other ideas they would be greatly appreciated. Thanks
January 25th 16 06:09 PM
by John Robertson Go to last post
2 440
Rowe R88 selection problem by [email protected]
Greetings, My R88 started exhibiting some strange behavior lately, it is playing the record a few beyond the one selected on the keypad. I have noticed, when first powering it on or when flipping the service switch off and then fully on again, the initial revolution of the carousel now goes 101...
January 15th 16 07:18 PM
by John Robertson Go to last post
7 801
What's the Pioneer CJ-V55 wall speakers look like by Dave277
I got my Pioneer Laser Juke working a couple months ago all 3 Players still going strong.I must say what an ausome sounding machine.Wanted to post that because I did a search and saw some negative posts as to reliability,etc... so I wanted to say if someone has one and wondering if it's worth the...
January 11th 16 09:50 PM
by Dave277 Go to last post
0 535
Rockola 478 32V breaker issue by David Brown
I have a 478 Mystic that works fine most of the time but occasionally will blow the 32V breaker. Since it works most of the time I thought the breaker might be weak so I removed it and tested it and it always blows over 2A. I pulled both the magazine and gripper motors and rebuilt them. I was...
January 11th 16 07:51 PM
by David Brown Go to last post
0 467
NSM ES160 Carriage Spring by DiabeticSyringe
Does anyone know where I can get a tension spring for the carriage? The spring keeps the proper pressure on the turntable. The for mine broke and so far I haven't found a good replacement. Thanks, Mike
January 11th 16 10:41 AM
by nhocbb82 Go to last post
3 473
United Juke Box Parts for sale by flipper
Still have United Juke parts for sale and they are old stock ...any interest?
January 9th 16 05:39 PM
by John Robertson Go to last post
1 550
Problem with Rock-Ola 484 by gioann
Hi, I have got a rock ola 484 it works quite well but there's a problem.All the switches banck A, B and D are in off position because I want it to work in free mode but I can select only the records with numbers 1 4 6 9 all other don't go. Maybe there's something I'm missing?? Can someone help...
January 9th 16 12:12 PM
by gioann Go to last post
0 464
1448 rockola by BikerAl
I have a rockola 1448 jukebox that was working fine until the other day. It now will not return the record when it has finnished playing.It just clicks in the on/off box inside the machine. Any advise please
January 8th 16 10:32 PM
by John Robertson Go to last post
3 556
Annoying Hum Coming From My Seeburg 1000 by Septo[_2_]
While playing my Seeburg 1000, every so often you'll get a very nasty, audible hum. Sometimes it gets louder than the music playing...is this the actual records (some of them are pretty beat) or the mech itself? Someone once mentioned something about motor bushings(?) possibly being the culprit....
December 24th 15 08:59 PM
by [email protected] Go to last post
1 772
Ami Jai-200 1958 problem with speed and sound by Lars Sima
Hi I have another problem with our jukebox. The sound has become a bit shaky and timing the rpm comes to around 42-43 rpm. I have read it could be the 3 rubber rings holding the motor in place, that become thin of aging. But could that also make the sound "shaky" (i'm not 100% sure about the...
December 21st 15 06:16 PM
by Lars Sima Go to last post
0 550
Ami jai-200 1958 problem by [email protected]
Hi We are asking for expert advice regarding this jukebox. We have a problem that the box cannot play some of our 45:s. It starts jumping and we cancel the record. Older 45:s seems to always be fine. Could it be related to the pressing technique? Is there something we can do? Its a "Diabolic"...
December 21st 15 06:08 PM
by Lars Sima Go to last post
5 633
WANTED: NSM Prestige ES160 service manual (with schematics) by [email protected]
Looking for NSM Prestige ES160 service manual (with schematics). The +5 volts led is off. John
December 19th 15 06:39 PM
by [email protected] Go to last post
0 482
Wurlitzer 1100 Continues Play by Tamster
I changed out my records to Christmas when I started it up to play, it want's to play the same record repeatedly. I can press different selections but still plays Rudolph over and over. Can anyone help me out with this problem? We played the jukebox a few weeks ago and it played fine. ...
December 12th 15 08:45 PM
by John Robertson Go to last post
1 450
Omt1015/45 by goldenconti
Hi who knows where we can download the Eprom image file for the OMT1015 vynil compatible with scc 40312
December 2nd 15 02:36 AM
by John Robertson Go to last post
1 544
Wurlitzer USA New Old Stock parts now up! by John Robertson
I have finally put up 99% of my NOS Wurlitzer parts stock: http://www.flippers.com/catalog/index.php/wurlitzer-m-22 Over 600 items! Some from the 50s, most is 60s and 70s. I hope to put up the parts manuals for the various machines in the next week to make it easier for you to find the part you...
November 15th 15 07:42 AM
by John Robertson Go to last post
0 630
Rockola 496 volume control/ drive gear by [email protected]
Hello- I recently acquired a 496 in decent shape. however, there are a few issues- There is no volume control, just some remaining cut wires coming off of the amp. Not sure I can get an old potemeter and build one? Also- the motor that drives the basket of records around works fine, but the...
November 13th 15 03:29 PM
by [email protected] Go to last post
0 471
NSM Satellite 200 Free Play Help by ComputerSpace
Hello all, I'm not sure how much this group is read, but I need to start somewhere... I picked up a fully working NSM Satellite 200 last weekend. It seems to be a great juke and I love the light organ built into it. I would like to program it for free play. I have the manual, here is what I've...
(Multi-page thread 1 2)
November 8th 15 10:42 PM
by John Robertson Go to last post
10 1,008
Post New Thread

Display Options
Showing threads 141 to 160 of 7123
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

All times are GMT +1. The time now is 12:36 AM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 2004-2018 CollectingBanter.
The comments are property of their posters.